FAST NORMAL SPEED is used for gluing ceramic tiles and terracotta to non-deformable surfaces such as concrete, cement screed and anhydrite, cement and cement-lime plaster, gypsum plasters and rigidly fixed gypsum plasterboards and gypsum-fiber boards. It can be used in indoor and outdoor construction on vertical and horizontal surfaces, in places not exposed to high deformation of the cladding due to temperature changes. It is possible to glue the tiles starting from the top. Due to its increased parameters, it is also suitable for gluing porcelain tiles inside rooms. In the case of deformable surfaces or greater loads, we suggest using FAST EXTRA SPEED.
Frost and waterproof adhesive mortar FAST NORMAL SPEED is a dry mineral mix, modified with synthetic polymers, characterised by high adhesion. Due to its properties, it is economical and easy to use. It is characterized by a very low flow, which allows the tiles to be glued from the top. Due to its quick setting parameters, it allows jointing the tiles after 6 hours.
bag - 25 kg
Product's photo
The surface should be even, strong and dry, free from all kinds of contaminants that would reduce the adhesion of the mortar, i.e. dust, lime, grease, remains of old paint coatings. In order to increase adhesion and eliminate dust, surfaces should always be primed with FAST GRUNT U or FAST GRUNT G.
The product can be used on the following surfaces:
Pour about 6 liters of water per 25 kg of dry product into the container and add the contents of the bag, stirring until the consistency of a homogenous paste is obtained. Leave for about 5 minutes and mix again before use (do not add water). The mortar prepared in this way can be used for a period of about 30 minutes. The tiles should not be soaked in water prior to laying.
Start laying the tiles by applying a layer of glue to the surface with the flat side of the trowel, and then collecting the excess with the comb side. The thickness of the teeth on the trowel depends on the type and size of the tiles. It should be remembered that the size of the surface on which the adhesive mortar is to be applied should allow for proper laying the tiles before the open drying time expires. If the mortar stops sticking to hands during work, it means that the time has been exceeded and it is necessary to remove the mortar and replace it with fresh one.
I t should be remembered that to ensure adequate adhesion, the adhesive mortar should cover at least 80% of the tile surface, and in humid places, exposed to intensive use and outside buildings, even 100%. The tiles should not be butt jointed. The size of the joint should depend on the dimensions of the tiles.
The works should be carried out in dry conditions with air and surface temperatures between +5°C and +25°C. Fresh claddings should be protected against unfavorable weather conditions until they are dry.
dry cement mixture with mineral fillers, modified with synthetic polymers.
about 7,5 l of water for 25 kg of dry product
Store in factory-sealed packages, in dry rooms, on pallets at a temperature of + 5°C to + 25°C. The shelf life is 12 months.
The product is irritant and contains cement, becomes alkaline after mixing with water. Avoid direct contact with the skin and protect the eyes. In case of contact with the eyes, rinse immediately with plenty of water and seek medical advice. Keep away from children.
