FAST AKRYL + is used to apply fine, thin-layer textured plaster coatings, both inside, and outside buildings. It can be used on any mineral surface that is sufficiently strong and even (cement, cement-lime plasters, concrete, reinforced layer in ETICS FAST S thermal insulation system).
FAST AKRYL + is a ready-to-use plaster based on acrylic dispersion enriched with silicone with texture. In comparison to traditional acrylic plasters, it is characterized by increased resistance to dirt and moisture. It is vapor permeable and surface hydrophobized, which limits the growth of microorganisms such as algae and fungi. It is flexible, resistant to mechanical damage and cracking. It is delivered in a wide range of colors acc. to FAST COLOR SYSTEM.
bucket - 15 kg
Product's photo
The surface should be even, strong and dry, free from all kinds of contaminants that would reduce the adhesion of the mortar, i.e. dust, lime, grease, remains of old paint coatings. In order to increase adhesion and eliminate dust, surfaces should always be primed with FAST GRUNT U or FAST GRUNT G.
The plaster can be used on the following surfaces:
Before starting plaster application, the contents of each package should be mixed with a slow-rotating drill in order to even out the consistency. If the mass is too dry, it is permissible to add 100 to 150 g of water. On a previously properly prepared and primed surface, apply the plaster in a thin layer, to the thickness of the grain, using a stainless steel trowel. After a short time, depending on the conditions at the time of application, it can be textured with a plastic trowel. Trowel the plaster with circular movements. When applying the plaster, the general
rule of applying “wet on wet” should be followed. It is also possible to apply this plaster using the spray method, which significantly reduces the cost and time of application. Details on the exact technology are available at www.fast.zgora.pl or from technical representatives.
Tools and container should be clean. When applying and drying the plaster, observe the appropriate weather conditions, i.e. surface and ambient temperature from + 5°C to + 25°C, no strong sunlight, no rain or too high relative air humidity above 75%. The drying time of the plaster at the optimum temperature of + 20°C is from 12 to 48 hours.
styrene-acrylic dispersion with the addition of mineral fillers and pigments
Store in factory-sealed packages, in dry rooms at a temperature of + 5°C to + 25°C.
While working, avoid direct contact with the skin and protect the eyes. In case of contact with the eyes, rinse immediately with plenty of water and seek medical advice. Rinse soiled skin immediately with plenty of water.
Keep away from children.
